skip to Main Content

Studio Renovation: Complete!

Studio Renovations
1. Studio Renovation: The Beginning (post 1 of 4)
2. Studio Renovation: Structural Repairs & Design Plans (post 2 of 4)
3. Studio Renovation: Planked Ceiling (post 3 of 4)
4. Studio Renovation: Complete!
5. Studio Renovation – here we go again!
6. Focusing on a Finish – Studio Bathroom Renovation
7. Studio Bathroom – sink, faucet, toilet, and tiles!

I’m doing all the happy dances over here, folks. The studio renovation is complete! CHECK IT OUT!!!!
studio17

studio02
Studio Ceiling in progress

When last we left off, the ceiling was planked, but not yet trimmed, and I had begun to paint the walls, ceiling, beams, and trim.

Well, there was about 40 more hours of painting that happened. I’m not even kidding about that time estimate. Painting a vaulted ceiling and a dozen 40-year-old trusses white is no joke. It took several coats of paint and a lot of patience. My love for my neighbor’s magical ladder only grew as I climbed up and down it hundreds of times (ladder is listed in resources list below). The walls, ceiling, and beams are all the same color—Behr’s Popped Corn–but the beams are a semi-gloss and the rest is flat. Truth be told, everything could probably use another coat or two of paint, but I’m out of paint and patience, so what I’ve got is going to suffice for now. And it’s more than good enough. I love it.

Jon did an amazing job finishing the edges and seams on the ceilings. We used the leftover boards from the ceiling to make a floor in the lofted space over the kitchen and bathroom. I transformed myself into a caulking goddess and closed up cracks in the ceiling and along the beams to create a more polished look. Jon took on the rather funky job of scraping all the old linoleum glue off the subfloor.

A big moment for me was when the beams and ceiling finally had enough paint on them and we could take down the ratty old light fixture that had been hanging in the middle of the room and hang this glorious ceiling fan.
studio03

Isn’t that the best fan? It was a bit of a splurge, but I just love how it looks (source below).
studio20

New white outlets covers and beautiful vintage switchplates were installed once painting was finished. Don’t worry, I caulked the edge of that trim, too.
studio01

Before the new floor went in, I tried to get anything that would require painting or a drilling done, so we also put in the wall mount for my TV. The speakers up above are connected to a Bluetooth receiver so that I can play music, NPR, audiobooks, or podcasts from my phone or iPad while I’m working. I plan on making fabric covers for the speakers, since the black is a bit stark.
studio18

studio4

On to the floor… I went through dozens of floor samples before settling on this floor. It’s a hardwood, ¾-inch thick, with a paper underlayment. The installation went very smoothly—Jon and I have installed floors before, this room is pretty close to being a plain rectangle; plus we borrowed an air compressor and floor nailer from our neighbor (sources below). Easy Peasy.
studio06
studio09
studio10
studio11

We used painted pine boards for the baseboards. We’re probably going to go back around and install quarter-round at base of these boards, but I want to live with it as-is before deciding for sure.
studio16

I’ve got all the curtain rod holders up. The curtain rod holders are from ikea, but I’m not using the rods that come with them (they are wood, and a set, short length). Rather, I’m planning on using 1-inch copper pipe as curtain rods. I say planning because I’ve only bought one and am going to live with it for a bit before deciding if that is indeed what I want. studio04

So there it is, my empty studio! I’m travelling to Atlanta to work at Sewtopia, but when I get back, I’ll finish clearing the tools out and moving in my furniture and fabric. I need to paint a few pieces before bringing them up here, but I’m looking forward to it. I’ll post photos of the furnished studio in a few months, once I’ve figured out what works best in this lovely room!
studio23
studio22

 

 

Resources (some links are affiliate links):
Awesome aluminum ladder: Little Giant Ladder System borrowed from neighbors
Air compressor: Dewalt borrowed from neighbors
Floor Nailer: Central Pneumatic borrowed from neighbors
Aqua paint: Refresh from Sherwin-Williams from Lowe’s (SW6751 or HGSW1306)
White paint: Popped Corn from Behr from Home Depot
Ceiling fan: Roto by Minka Aire
TV mount: Full-motion Kanto mount
Floor: Jasper Hardwood, European brushed, White from Build Direct
Outlet covers: Bought in bulk from Amazon
Switch plates: Vintage, found on Etsy.com
Curtain rod holders: Sannolikt from Ikea, painted white
Curtain rods (not shown): 1-inch Copper pipe from local hardware store.

This Post Has 10 Comments

  1. Fantastic! And having put in all of that sweat equity must make it feel even more special, and more YOURS, than if you had hired someone to do all of that work. Kudos to your husband too. enjoy!

  2. Sooooo beautiful! You well have a lot of fun creating in this special space! Congrats!

  3. so exciting!!!! Love the green accents you’ve already got going in there. So much hard work, but it looks amazing!

  4. So exciting Rossie! I love what you’ve done and admire your hard work and your team work. That says a lot. I am excited to see how the furniture rolls out. I am happy for you!

    Michelle
    in Seattle

  5. Congrats! Thanks for sharing the process. Looking forward to seeing it once you move in your furniture.

  6. A huge congrats on your (not brand new now) studio! I have the same ceiling fan in my newly renovated studio and I love it. I hope you enjoy your new space as much as I have enjoyed mine. Was just thinking about you as I peeled paper off my acrylic shapes!

Comments are closed.

Back To Top